CasablancaForum.us

I'm using the S4000 Pro with Bogart 2.0C.

After a few months there were some problems that forced me to do a destructive install. All the problems were corrected, or so I thought. After finishing a small project I went to Arabesk and there was no response....it would not open up.

So far I tried removing and reinstalling Arabesk. It regisers as being active, but it will not open.

Are there any ideas as to the solution? The install disc I have was sent with the equipment and Arabesk worked for a few months.

Hi Wayne

I had the same problem the button is there but you can't activate it. You have to run Arabesk 4.1e for that I don't know the download shortcut to that (sorry) I just can't find it may be contact Macrosystems US for that.

If you are running Bogart 2, you should be running Arabesk 4.1e. If you do not have a current all software disc with it, you can download one from our site.


Dennis