CasablancaForum.us

I WAS WORKING WITH MY RENONMEE PLUS(5 WEDDINGS), AND TONIGHT MOVING
THE TRACK BALL,THE VIDEO AND SOUND WHENT OFF.
SO I DISCONECT EVERYTHING BEHIND THE RENONMEE ALL NIGHT,WAKE UP THIS MORNIG
AND NO NOTHING,NO NADA,THIS MACHINE WHONT START .PLEASE ANY HELP
TO TRY THIS EDITOR COMES UP AGAIN WILL APPRECIATE....

Franklin

ps- I CHANGE TO OTHER HARD DRIVE AND NOTHING HAPPENS.....

.Are you getting power? If not, power supply is the culprit

.Not booting-up in the Renomee? The Bios are set to boot-up to the CD/DVD drive. Are you getting any response on boot-up (green light) from the DVD/CD drive?


If no response, I will send you the procedure I saved from a prior post.

LOU !!!...NO GREEN LIGHT NO BOOT-UP WHEN I TURN ON, ONLY A FEW SECONDS RED LIGHT AND THEN
THE NORMAL YELLOW(LIGHT ON LEFT),LIGHT !!

COPIED FROM A PRIOR POST:


Here's the procedure I got from Bruce regarding rebooting my Renommee Plus:

1. Make sure there is no disc in your DVD burner.

2. Have the unit connected to both a VGA and regular video monitor, and have a keyboard and trackball connected.

3. Start the machine.

4. When you see the first activity on the VGA, press the Delete key on the keyboard.
This should take you to the Bios Setup Utility.

5. Right arrow across to the boot section and select Boot Device Priority.

6. Select 1st boot priority and press Enter.
Highlight the Pioneer burner and press Enter.

7. Select 2nd boot priority and press Enter.
Highlight Casablanca BEV and press Enter.

8. Select 3rd boot priority and press Enter.
Highlight ST300 (not sure of the complete number) and press Enter.

9. Select 4th boot priority and press Enter.
Highlight Disabled and press Enter.

10. Press F10 and then OK to save settings.

System shoud now reboot to main menu on the video screen. This may take about 60 seconds.

From there on you can go to System Settings to install your software from the "All Software CD".

Be careful, (this applies to Reno Plus or a Sol Plus owners), not to install Smart Edit 5.1c from the "All Software CD".

If you are adding new drives, be sure to use only the 5.1c Renommee boot disc.

Len

  HEY LOU !! NO VGA SIGNAL,NO . NOTHING,ANY OPTION?
PLEASE I DON'T WHANT TO RE EDIT 5 WEDDINGS....

I CALL TECH SUPPORT AT MS....CROSS MY FINGERS....

Today before send this R-plus to Boulder I give him a chance
to try to work !!! and IS WORKIN AGAIN
this is a MIRACLE

Franklin

Check the connections to your DVD/CD drive. The bios are set to boot-up after recognizing an active CD/DVD drive. Possibly you have a loose connection to the drive or your CD/DVD drive may have problems.

How is the "S" model working?

Franklinbencosme wrote:Today before send this R-plus to Boulder I give him a chance
to try to work !!! and IS WORKIN AGAIN
this is a MIRACLE

Franklin

So it just started working again?

You sure you don't have a bad electrical bar or something?

Lou, yes R-plus and S-pro are working !!!...