CasablancaForum.us

I operate a Prestige SE 8.1

When inserting a title into a scene it displays for only half the specfied range.
i.e. In a (Example) 20 sec. scene a title is added to run the entire scene lengh - only 10 seconds will display. If 6 seconds are specified - only 3 will show.
No matter if I check 'Entire Scene' or select a range no matter what I do - only 50% of the title's desired range is added to the scene.
Tried everything and ran out of ideas - can anyone help?

I bet you have an "empty" page in your titler that will be displayed after the actual title.
Just delete this empty page in your titling engine and there you go.
Good luck.

Than You Volker for your speedy response - You were right on the money.

All the best, Ilan