Page 1 of 1
page turning
Posted: Sat Mar 27, 2010 9:37 pm
by videojim
Among the transitions I do NOT find a simple page turn. Is this available on the Renomee, and how? Thanks!
Re: page turning
Posted: Sat Mar 27, 2010 10:42 pm
by Jeanton
Hi Jim
You don't find it at the P but it is called Z1 Page Turn it is one of the last transitions because of the Z
Re: page turning
Posted: Sun Mar 28, 2010 6:37 am
by TimKennelly
As Jeanton mentioned, you have it Jim as it is part of Pro Pack which ships with all third generation units.
Why they call it Z1 Page Turn is from back in days of old when most of the MS transitions were fairly plain and this was created with a pack of them that they felt used more than just the x and y axis.
It was confusing in the alphabetical scroll through transitions then as well though. LOL
Re: page turning
Posted: Sun Mar 28, 2010 6:21 pm
by videojim
Well, it does use the Z axis, because it comes at you a bit, so i understand that. Will look for it, there. Thanks, y'all!