Page 1 of 1
what's goin on?
Posted: Thu Apr 07, 2011 2:27 pm
by videojim
I put in a disk to burn a storyboard as an AVI. The verify part says it could not finish the verify process. A 13:53 storyboard gets read as a 9:03 file on the import side. Push display contents and a 13:53 storyboard has lost almost 5 minutes! On import, it spends not even 20 seconds and quits, without importing anything. What's makin this happen?
Re: what's goin on?
Posted: Thu Apr 07, 2011 3:22 pm
by LouBruno
.Corrupt file
.Over modulated or BAD audio
Re: what's goin on?
Posted: Thu Apr 07, 2011 8:27 pm
by videojim
Will go back and check on audio levels, but don't think there is one. These were silent motion videos. And HOW would a file get corrupted when it has just been created via use of the scene button, and slapped back into the scene bin, and then saved as an AVI? When and where would corruption have happened? Not disputing that it could have, just don't understand when/where? It was saved as an AVI, and then saved right back into the same project to make sure it would save. Just verifying the whole process, is all.