Page 1 of 1

HD Auto Split on the 6000

Posted: Fri Jul 27, 2012 9:54 am
by methuenbill
Are there special settings for HD on the 6000? I have loaded a Hd file and did Auto Split. The split starts a few frames from the previous one. So I go to each scene and trim a few frames off.

Re: HD Auto Split on the 6000

Posted: Thu Aug 02, 2012 3:25 am
by MichaelD
If this is consistent (always the same amount of frames to trim off) then you can set Bogart to automatically adjust the in and out cut points.

Settings, Record/Playback - AVCHD Shorten in (or out if it's at the end) - this is for AVCHD recording only.

If it's HDV (tape) that you're doing then make sure that the Auto Split is set for 'Start Code' and not 'Time' or 'Automatic'.