Page 1 of 1
s6000 problem
Posted: Wed Feb 19, 2014 10:15 pm
by johno
our s6000 has a problem or two. can't turn off by pushing the power button and i'm trying to install new software and nothing shows up on the monitor and the fron light blinks. any suggestions. thanks
Re: s6000 problem
Posted: Thu Feb 20, 2014 3:49 am
by IanPearson
Just to the right of the front USB sockets, there is a small reset button, just gently press this using a pencil point or some other implement.
This will restart your S6000, although you may lose some of you latest editing work.
Ian
Re: s6000 problem
Posted: Thu Feb 20, 2014 1:02 pm
by MichaelD
It's 'possibly' trying to display on another screen/output if it's Bogart you're trying to update
Can you connect something else up to it
Alternatively using the re-set button (suggested by Ian) try using the "v" key during boot up, just after the beep(s) to change the S6000's output . . .
Re: s6000 problem
Posted: Thu Feb 20, 2014 9:10 pm
by Franklinbencosme
Johno get ready for a FULL INSTALL
this happen to me 3 times and all my work was gone
but after
5.5c my s-6000 is more stable,a few crash during editing,always try to BACKUP this will make you a better
sleeping editor !
Good luck !