Page 1 of 1

audio question!

Posted: Fri Aug 01, 2014 12:09 pm
by flvideo
I shot a job for a nursery of 3 individuals speaking. At least thats what I was told up front. When they got into their speaking they each spoke for a tme which is fine then they went into question and answer mode. Obviously when the audience was speaking I had dead air. Then at the end of the last speaker they got all 3 together and talked. I had the last speaker wired so the other 2 were very low. I am having a fit editing. I have managed to put it together pretty well till this last where the 3 are together and I am having a fit with it. I tried splitting and raising the level when the 2 that were un-mic'ed were talking but thats not working well! Any advise?

Re: audio question!

Posted: Mon Aug 04, 2014 1:39 pm
by Christopher6206
You should be able to use the envelope feature in the audio mix screen to do this. No need to split clips and raise the audio for the clips that are low. Just work with the existing audio and use envelope to raise and lower where necessary.