Page 1 of 1

Title Studio question

Posted: Fri Dec 05, 2014 7:18 am
by bethklinger
When using the V-scroll effect in Title Studio (1.2) with B6.1 on my S6000. I've only been able to get a little more than HALF the time over the selected scene to create the message. I had a scene selected that was 1 minute long and only got 37 secs ... then another scene was 40 secs long and I only got 24 secs. I tried the same in B4W on the PC and all was ok is that TS version 2.0?

I also tried using the Scaling V Scroll with the same message (on the S6000) and it scrolled the entire scene but didn't get the whole message!

Any one else try this?
Beth Klinger

Re: Title Studio question

Posted: Fri Dec 05, 2014 7:37 am
by LouBruno
Can you give us a step by step?

Re: Title Studio question

Posted: Fri Dec 05, 2014 10:22 am
by bethklinger
Thanks Lou.
At the end of my projects (photo montages) I put a poem over a selected scene, that scene is usually 1 min 5 secs long. I place this scene up on the story board, go to title menu and add the title (scene shows the correct length of time) I choose V-scroll, then enter/edit text, type in the poem I want, click ok, go to "scene" then "effect and scene" or "range" (I've tried both) create scene in scene bin and click ok. Let it render out and it scrolls the entire poem but only uses a little more than half the scene when completed.

Same process for Scaling v-scroll, this does scroll the entire scene only when it's done it leaves out the last 4 lines of the poem.

I should repeat that this is only happening on my S6000 with OS 6.1 not B4W.
Beth Klinger