Page 1 of 1
add a menue at the begining of a film
Posted: Tue May 14, 2013 10:58 pm
by mb3514
I have an S6000
I can not figure out where to creat an opening menu!
I can not find instructions in the instruction manual.
HELP
mb
Re: add a menue at the begining of a film
Posted: Thu May 16, 2013 9:17 am
by MichaelD
Why not just use the 'assistant' - it asks most of the right questions and then lets you 'edit' the results prior to a burn . . .
Re: add a menu at the begining of a film
Posted: Fri May 17, 2013 1:18 am
by mb3514
In my arabesk menu, the Assistant and Edit Menu button will not activate. When I click on them nothing happens?
Any suggestions?
Thanks
mb
Re: add a menue at the begining of a film
Posted: Fri May 17, 2013 5:11 am
by BobFoster
Maybe it's time to go to the software listing and delete Arabesk and re-install it. If some functions are not working correctly, the software may be corrupted. Be sure you have the license number handy either written down or on a usb thumb drive.
Re: add a menue at the begining of a film
Posted: Sat May 18, 2013 7:43 am
by CasablancaExpert
mb,
My guess is this - if you enter DVD Arabesk from a different project, preferably a new - empty project the buttons will appear and allow you to move forward.
I have had this happen when clicking into Arabesk from the project I wish to author from/in, that some of the buttons are unavailable... or the project data when going to Add Film is not consistent or accurate with the project I am adding. Just pop out of Arabesk, enter a new project and launch from that project and voila (cannot explain why and do not suggest this is 'ok' behavior - but this work-around always works for me).
Regards,
Chet