dvd BURNER

[JDEANO]

MY RENOMEE WILL NOT BURN A DVD. EVERTHING IN THE EDIT SECTION RUNS FINE, BUT WHEN I GO TO THE FINISH WINDOW TO PRODUCE THE DVD i GET ALL KINDS OF PROBLEMS AND THE ARABESK 3 WILL NOT PERFORM. WHEN I GET TO WRITE DVD LINE THE UNIT GOES DIRECTLY TO THE SECOND PHASE BAR AND THEN I CAN'T DO ANYTHING UNTIL i UINPLUG THE AVIO. I'VE TRYED DIFFERENT PROCEDURES, BUT NOTHING HELPS. cAN ANYONE GIVE ME SOME ADVICE? tHANKS. D. PHIPPS

[BobFoster]

1st make sure all old DVD films have been deleted before adding the current one. (My frequent mistake)
Possibly the Arabesk software has become corrupt. A simple delete of the Arabesk program and then re-install from the all software disc will give you a fresh start with Arabesk without messing with your storyboard or other program partitions. i GET ALL KINDS OF PROBLEMS AND THE ARABESK 3 WILL NOT PERFORM. WHEN I GET TO WRITE DVD What kind of problems are you experiencing

[JDEANO]

wHEN I GET TO THE WRITE DVD AND INSERT A DISC THE NORMAL TIME LINE APPEARS FOR A SECOND AND THEN IT GOES DIRECLY TO THE SECOND PHASE SCROLL. OTHER TIMES THE AVIO GOES TO THE WRITE PHASE AFTER I GO TO THE ADD MOVIE SCROLL. IT GOES THROUGH THE WRITE DVD OPERATION BUT THE DISC IS BLANK. THERE ARE ALSO OTHER COMBINATIONS THAT ARE'NT NORMAL. iT DOES APPEAR AS THOUGH THE ARABESK SYSTEM IS CORRUPTED AND MIGHT BE CORRECTED WITH A REINSTALL. ANY OTHER RECOMENDATIONS ? THANKS. DEAN

[TimKennelly]

You have tried switching to Disk Transfer and back to see if that would clear the glitching?

You tried deleting Arabesk and reinstalling it?