Rendering film with Renommee Plus.

[mykle]

I have a strange, little ”problem” when rendering film on my Renommee Plus. When starting the rendering, horizontally stripes appear all over the monitor, until the blue progressing bar comes right over the letter “a” in the textfield “Cancel” (Every time!).

Thereafter the monitor is clean. When rendering, the yellow diode on the front is constantly lit, and the red diode (to the right) is blinking, until the blue bar reaches the letter “a”. Then it turns over to be constantly lit until the rendering is finished.

However, this “problem” doesn’t seem to influence the making of DVD’s. I have Arabesk 4.1d now, but this also happened with earlier versions of Arabesk, with my Renommee Plus. But, what makes those stripes?

[PaulBusta]

That is strange, I have a NTSC Reno+ and never had a problem like that.

[Martyn]

It is not unusual to see slight interference lines on the monitor when Renommee is working hard. These may also be visible when authoring DVD's. When carrying out o/s installation coloured bands may also be seen across the screen.

Martyn
Dalco uk

[LouBruno]

Known issue. Doesn't effect the final rendering product.

[HansJoachimKoenig]

Machines must be different? Never had this problem.