Bogart S2000

[sid1931]

Thanks to all for your helpful recommendations and comments.

Last evening I plugged the Bogart into my TV set and lo and behold there was a response. So I installed the operating system and most of the software. It turned out that the original hard drive had indeed failed. Now, with the new Seagate 1TB hard drive it says I have 69 hours of video recording time!

Right now I am operating using the AV input of my Samsung TV. It has been years since I set up the Bogart to operate on HDMI. Can anyone give me a quick synopsis of how to change from the AV input to the HDMI setting?

Many thanks and best wishes,
Sid
skleiner@comcast.net

[HansJoachimKoenig]

Hi sid1931,

you may change the desired output.
When MacroSystem is shown (Not Macro( )System)
Connect your S2000 via HDMI-cable to HDMI monitor
Press the right button of the trackball for 3 seconds
If no response press the left button to continue the monitor selection
Continue pressing left button for output change
The left button changes outputs DVI/VGA--> DVI/HDMI--> HDMI

Good success

[sid1931]

Many thanks for the valuable input! I just couldn't remember how I brought in the HDMI mode a few years ago and couldn't find the instructions in my notes.

Regardless, I was able to make the switch last evening and I am now editing in HDMI!

Again, thanks,
Sid

[HansJoachimKoenig]

Hi sid,

I am happy with you since now all is working as you have wished