I have a question about Arabesk 4.0d running on my Kron Plus with SE 8.1. The burner is a Pioneer DVR-106D with firmware version 1.08.
I edited a project shot in 16:9 that ended up being 1 hour and 51 minutes in length. I added it to Arabesk (which I use rather infrequently) and hit cancel when it asked if I wanted to change the film (and use the assistant?). I chose normal video and compressed audio. The film added and rendered and I burned a DVD on a Taiyo Yuden disc with no issues except that I chose no box around the arrow button but it drew one anyway.
When I put the DVD into a player – stand alone or my computer – the total time shows something like 2 hours and 10 minutes, but it actually runs for the correct time (1:51) and then stops. Is this normal or is there something that I set improperly? Should I (or can I) uninstall and re-install Arabesk?
Arabesk 4 Run Time Inaccurate
-
CKNewman
- Posts: 604
- Joined: Tue Mar 25, 2008 2:56 am
- Casablanca Unit: Windows computer with Bogart SE 13.3, Arabesk 7, Audio Effects Pack v1.2b, Motion 3D XL-1 Pack 1, Sentry HD-Backup, Disk Juggler, Power Key, Aspector, Chromit, Effects Pack 8, Effect Pack 9, PiP Studio 3, Time-X, Ultimate Spice Box HD, Slivers, PIP Studio 4 ; Older windows computer with Bogart 8.4, Arabesk 7; Kron Plus with SE 8.3, most Generation 2 software except for CB Paint, Columbus, titling add-ons, and graphics symbols. Various TVs and a Kenner Give-A-Show Projector
- Location: Boston, MA
- Contact:
Arabesk 4 Run Time Inaccurate
Craig Newman
Who is online
Users browsing this forum: No registered users and 39 guests